• Telescoping design fully extends to 14'
• Only 17.5" long when retracted.
• Unique tip design will both pull and push the wire & cable.
• Glow tip for working in dark areas.

• Features the patented EZ-RJ45 Crimp Tool for crimping RJ-11, RJ-12, RJ-45 and EZ-RJ45 connectors.
• Kits include the EZ-RJ45 Cat 5 connector.

• Crimps and trims extended wire in EZ-RJ45 Connector in a single cycle.
• For use with EZ-RJ45 Cat 5/5e & Cat 6 Connectors.
• Will also work on most other RJ-11, RJ-12 and RJ-45 connectors. (Except AMP)
• Patented

• Thru holes allow wire pairs to be inserted thru front of connector.
• Works with solid or stranded wire.
• Simple one piece design...no bars or liners.
• FCC compliant, UL rated.
• Use in category 3, 5, 5E compliant data networks.
• EZ to verify wire sequence.
• Faster terminations.

• For use in Cat 6 compliant data networks.
• Category 6 performance per EIA/TIA B.2.
• EZ to verify wire sequence.
• Works with solid or stranded wire.
• Faster terminations with reduced scrap.
• FCC compliant, UL rated.
• Simple one piece design...no bars or liners.

• Spanner Security 4, 6, 8,10.
• Torx Security 10, 15, 20, 25.
• Slotted 7/32.
• Hex Security 1/8, 9/64, 5/32, 3/16.
• Roberts Security 1,2.
• Phillips 2.

• Prolong patch cord life
• Maintain bend radiuses required for standards compliance
• Terminations have a professional finished look
• No more snags or hang ups, causing tangled messes
• Easier to unlock the connector when unplugging from jack/port

• Thru holes allow wire pairs to be inserted thru front of connector.
• Works with solid or stranded wire.
• Simple one piece design...no bars or liners.
• FCC compliant, UL rated.
• Use in category 3, 5, 5E compliant data networks.
• EZ to verify wire sequence.
• Faster terminations.

• Internet Line Test
• OSD menu is used easily
• Auto-identify NTSC, PAL
• Low power consumption / once charged, the power can be used for 4-5 hours
• Support RS232 and RS485 syncchronically
• Auto-reduce power consumption
• 2.5" inch LCD
• Exterior power: DC9V(2A)
• Interior Voltage: DC/3.6V 1200mah Lithium Battery

• 3.5" Color TFT LCD
• 480 (W) x 234 (H)
• CCFL back light
• 10,000 hour min lamp life-time at 25C temp
• 150:1 typical contrast ratio

• 4 Video Port Analog to Digital Converter
• USB Connector

• Digital (VGA) to Analog (TV RCA)
• Conv:1280*1024
• w/ rem
• control (display PC on TV)

• Video & Audio input
• Resolution 480 x 234 (dot)
• Coaxial cable quality test: open, short, excellent, good, poor mode defected
• Built-in 0.5W Speaker
• Auto Power saving design
• Low battery warning
• Prevent incautious on/off operation design
• Full packing complete
• 2200mA Li battery included
• 250mA consumption
• DC12V output for camera

• 8 Port Passive UTP Tx/Rx Module
• No power required for up to 1000 feet
• SCW-8337 8 Port

• Includes a VB-3 Transmitter
• Includes a VB-3 Receiver
• 1 Vp-p 75Ohms (BNC Connector)

• Video import: 1Vp-p/75 ohms, 8-channel
• Video export: 1Vp-p/75 ohms, 1-channel
• Image degree of separation: > or =40dB
• Signal bandwidth: 2MHz, +/-3dB
• Switching time: 1 sec-45 secs
• Channel switch: side road/automatic

• Li-Ion Rechargeable Battery Pack

• Video Distributor 1 in 4 out Audio/Video
• w/ Gain Control per Channel

• Helps to prevent video-signal distortion caused by video ground loops
• Helps to eliminate picture tearing, cross talk and rolling
• Built in surge suppression
• BNC male to BNC female
• Passive, no power required

• Video Distribution
• 1 input channel
• 2 output channels
• Video input levels 0.8~1.2V pp 75 Ohm
• Video output level 1V pp
• Dimensions: 49 x 42 x 50mm
• Power: 12VDC 100ma
• Transmission range up to 300M
• Connectors BNC
• Compatible with NTSC or PAL

• DB9, RS232 female connector to 2 wire terminal block for RS485
• Two wire, differential signals, half duplex
• Passive, no power required
• Power consumption, 10ma max
• Auto switching baud rate
• Speeds up to 115,200 baud over a distance of 1200 meters
• Up to 32 units connected together in RS-485 multidrop operation.

BNC male to BNC female

• Quickly and reliably tests coax cable terminated with BNC Connectors
• Test coax cabling for opens and shorts
• Two modes of operation 50/75 Ohm and 500 Ohm terminators
• Two modes of operation: standard and Hi-Z for Long runs
• Test Coax for opens and shorts
• Six-volt battery installed in tester
• Easy to operate